Use /tool/traceroute specifying the routing-table=to_v2ray to track where packets are dropping.
Run /container/print and ensure status reads running .
/ip route add dst-address=0.0.0.0/0 gateway=192.168.88.10 routing-mark=to-v2ray
: Give the VETH interface an IP address (e.g., 172.17.0.1/24 ) and assign the container a static IP (e.g., 172.17.0.2 ). v2ray mikrotik
Install Debian or Ubuntu on your local gateway machine and ensure IP forwarding is enabled. Run the following commands:
/container/envs/add name=v2ray_env key=CONFIG_JSON value="your_full_base64_config_here" Use code with caution. 2. Add and Start the Container
External USB drive or MicroSD card formatted to ext4 (strongly recommended to save internal flash memory rewrite cycles). Install Debian or Ubuntu on your local gateway
Now that V2Ray is running inside your MikroTik at 172.16.10.2:10808 , you must intercept local network traffic and send it to the proxy.
: Running containers adds CPU overhead. If you notice 100% CPU utilization on small boards (like the hAP ac2/ac3), consider narrowing down the number of devices allowed to route traffic through the V2Ray client. If you need help tailoring this setup further, let me know: What specific model of MikroTik router are you using?
Then bind container’s proxy port to a local address and redirect traffic as in Method 1. Add and Start the Container External USB drive
Every device in your home or office connected to the router is automatically protected, including IoT devices that don't support VPN clients.
She sat in her dimly lit workshop, the rhythmic blinking of a MikroTik RB5009
/container add \ remote-image=v2fly/v2fly-core:latest \ interface=veth1 \ mounts=v2ray-conf \ cmd="run -c /etc/v2ray/config.json"