Xta-7000 Temperature Controller Manual Jun 2026

For the best results, use the Auto-tuning function to let the XTA-7000 calculate the ideal P, I, and D values for your specific environment: Navigate to the parameter. Change the value from oFF to on .

If your system is using an On-Off control mode near the target temperature, the relay will rapidly switch on and off. Switching to a PIDcap P cap I cap D

Ensure the panel cutout meets the specified dimensions (typically DIN depending on model) to ensure a snug fit.

Indicates the Process Value (actual measured temperature). xta-7000 temperature controller manual

Meaning: The displayed temperature changes drastically but does not match reality.

PID Control (with Auto-Tuning) or ON/OFF Control Sampling Cycle: 0.5 seconds Accuracy: ±0.5% of full scale 2. Terminal Wiring Diagram & Installation

| Parameter | Name | Function | Typical Value | | :--- | :--- | :--- | :--- | | | Proportional Band | Control sensitivity. Lower = faster response, higher = stable but slow. | 30.0 (start here) | | I | Integral Time | Eliminates steady-state error. Lower = faster elimination (risk of oscillation). | 240 seconds | | D | Derivative Time | Anticipates future error. Prevents overshoot. | 60 seconds | | Ar | Anti-Reset Windup | Limits integral action when output saturates. | 1.0 | | Sc | Sensor Correction | Offsets a faulty sensor reading. | 0.0 | | At | Auto-tune Enable | 0 =Off, 1 =On (self-tune), 2 =On with light overshoot. | 1 | | AL1 | Alarm 1 Mode | 0 =No alarm, 1 =Absolute high, 2 =Absolute low, 3 =Deviation high/low. | 1 | | HY | Hysteresis (for On/Off mode) | Deadband to prevent relay chattering. | 2.0 | For the best results, use the Auto-tuning function

Disclaimer: This guide is a community-contributed manual based on common XTA-7000 firmware versions (v5.0–v7.2). For specific electrical ratings or hazardous area use, always cross-reference with the official documentation provided with your unit.

Press the key again to save your entry. The display will stop flashing, and the controller will begin regulating toward the new target. 5. Advanced Parameter Configuration Matrix

The XTA-7000 features a multi-tiered menu system. Most setup procedures involve modifying the Target Set Value or running the Auto-Tuning cycle. Changing the Target Temperature (SV) Switching to a PIDcap P cap I cap

Verify the output indicator light is on. If not, check PID settings or the Alarm settings. If it is on but no heat, check the external relay/SSR.

Failure to follow these instructions may damage the unit or create a fire hazard.

Fix: Inspect the thermocouple or RTD wire for physical breaks. Ensure the positive and negative terminals are not reversed. Check that the InP parameter matches your physical sensor type. Meaning: Input sensor short-circuit or under-range error.

Connect your AC power lines here (Line and Neutral). Control Output (Terminals 3, 4 & 5):