Back to Top

Xh-m608 Manual ✰ <Validated>

When operating under , long-pressing the DEC button from the main screen displays the remaining active countdown timer. 4. Performing a Factory Hard Reset

The is a versatile, digital battery charge and discharge control module . It functions as a programmable voltage switch to protect batteries from overcharging and deep discharging. This comprehensive guide covers specifications, wiring configurations, programming steps, and troubleshooting. 1. Technical Specifications

is a DC 6–40V battery charge/discharge module that integrates a voltmeter and a relay to automate battery protection and management. It is widely used for DIY energy projects, such as solar charging or protecting lithium and lead-acid batteries from over-discharge. Key Specifications Voltage Range:

This module is widely used in the following scenarios: Xh-m608 Manual

The voltage limits are set too close together. When a load turns on, the battery voltage naturally drops slightly, causing the module to turn back off instantly.

The feature adds time-based safety limits to your battery management.

Adjust the display value until it matches your known accurate multimeter reading. When operating under , long-pressing the DEC button

Wire the of the external charger directly to the Battery Negative (-) terminal. XH-M608 Battery Charge - Discharge Circuit - Motorobit.com

Connect the to the module's power input terminals.

Designed for charging profiles. The relay closes (turns ON) when the voltage drops to the P1 limit to start charging, and opens (turns OFF) when the voltage reaches the P2 limit to prevent overcharging. It functions as a programmable voltage switch to

[ Power Source + ] --------> [ Vin + ] [ Vout + ] --------> [ Battery + ] [ Power Source - ] --------> [ Vin - ] [ Vout - ] --------> [ Battery - ]

Ultimate Guide to the XH-M608 Battery Charge Control Module: Manual and Setup

The voltage at which the relay closes (turns on).

: Displays live voltage tracking, menu selections, and set parameters.

Connect your (appliance, inverter, light) to the OUT+ terminal. Connect your Load Negative (-) to the OUT- terminal. Troubleshooting Common Issues The display reads "ERR"