To use the software effectively, you need three key components:
Buy a cable specifically listed as "For HYT/Hytera TC-580." Look for one with a FTDI chipset (not Prolific) for Windows 10/11 stability.
For organizations with multiple TC-580 radios, create a master configuration file with your desired settings (frequencies, tones, power levels, etc.). Use this file to program all radios, ensuring consistency across your fleet.
| Specification | Details | |---|---| | | VHF: 136–174 MHz; UHF: 350–390 MHz, 400–470 MHz | | Channel Capacity | 256 channels (32 zones) | | Channel Spacing | 25 kHz (wide) / 12.5 kHz (narrow) | | Operating Voltage | 7.4V DC | | Battery Options | 1650mAh (standard), 1100mAh, 2000mAh | | Battery Life (5/5/90 duty cycle) | Up to 13 hours (2000mAh battery) | | RF Power Output | VHF: 5W/1W; UHF: 4W/1W | | Dimensions | 117mm × 53mm × 36mm | | Weight | Approx. 287g (with antenna and battery) | | Sensitivity | ≤ 0.25/0.28μV | | Receiver Audio Power Output | 1W | Hyt Tc-580 Programming Software
: Ensure the battery is fully charged to prevent shutdown during the write process.
Once your setup is complete, you can begin reading and writing data to the radio. 1. Reading Existing Data
If you manage security teams, work in construction, or coordinate events, you know the HYT TC-580 is a workhorse of a two-way radio. Its rugged design and clear audio make it a favorite. To use the software effectively, you need three
Click the icon, or navigate to Program -> Write to Radio .
Go to File -> Save As and save this factory file as a backup (e.g., TC580_Backup.dat ). Step 4: Edit Frequencies and Channels
This specific cable features a multi-pin connector that secures to the side accessory port of the TC-580. A standard USB-to-serial chip (like FTDI or Prolific) is embedded in the connector. | Specification | Details | |---|---| | |
Click > Save As and name your profile (e.g., Company_Channels_2026.dat ). Click the Write icon (or Program > Write to Radio ).
Instead of just showing "CH 01," you can type a custom name like "DISPATCH" or "GATE 1" up to 8 characters long.
Insert the 2-pin connector firmly into the radio's accessory jack. Connect the USB end to your PC. Turn on the radio volume knob to approximately 50%.
: Customize RX/TX frequencies, bandwidth (12.5/25 KHz), and squelch levels.
