Group all bolts, nuts, washers, and pulleys by size. Do not mix them up, as similar-looking bolts have different thread pitches and lengths.
Loop it back down to the front extension arm for low rows and leg curls.
Both cables should move freely without crossing. The pulleys must rotate in the same plane (no diagonal pull). dp dual trac 20 assembly instructions full
This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.
Slide one thick rubber donut bumper onto the bottom of each guide rod. These cushion the weight plates when they are lowered. Step 3: Loading the Weight Stack Group all bolts, nuts, washers, and pulleys by size
Do not tighten any bolts completely until the entire frame is assembled. Keeping the hardware hand-tight allows the frame to flex and align properly. Step 1: Base Frame Assembly
Before you begin, clear a 6' x 8' space for the machine and grab the following tools: Two adjustable wrenches (or a socket set) A Phillips head screwdriver A rubber mallet (optional, for seating end caps) Both cables should move freely without crossing
If you want to troubleshoot specific assembly issues, tell me:
: Useful for locating model numbers usually found on the rear main frame near the floor stabilizers. Step-by-Step Assembly Overview Base and Stabilizers