Canon Service Support Tool V475 Ep Full Upd Jun 2026

Updating the main operating system of the copier. BootROM: Updating the initial boot software.

Canon has since released newer versions (v4.81, v5.600, etc.), but v4.75Ep remains perfectly adequate for all imageRUNNER ADVANCE and similar models that require a version 4.xx Service Support Tool.

: Pentium 166 MHz or higher with at least 64 MB of RAM. Storage : Approximately 600 MB of free hard disk space.

: Downloading, uploading, and deleting backup data or firmware files.

The tool will flash the firmware, after which the machine will automatically restart or prompt for a manual restart. Troubleshooting SST Errors canon service support tool v475 ep full

Are you trying to (like an E602 hard drive error)?

The Canon Service Support Tool version 4.75Ep is designed to support a range of Canon devices, with a primary focus on the company's professional and enterprise lines. The official version 4.75Ep documentation identifies it as a tool for Canon copiers, especially those in the imageRUNNER (iR) series. It is specifically designed for series devices, providing a graphical interface between a computer and these copiers for various functions, including firmware upgrades and RAM data management.

If you encounter , it usually means the tool version doesn't support that specific printer model. In these cases, you may need a newer version like v4.81Er or even v5.0+ for the latest hardware. Perform Maintenance With Printer Assistant in Windows

The PC with SST must be placed in the same subnet. Change your PC’s network adapter settings to: Updating the main operating system of the copier

A complete v4.75 Ep installation package typically contains several distinct components:

: Originally designed for Windows 2000, XP, Vista (32-bit), and 7/8/8.1.

: Resolved error detection issues when connecting to "Assist Mode" and fixed wrong timeout judgments during new HDD formatting.

: Prohibited downloading different versions of SYSTEM firmware in Single mode to prevent system conflicts. : Pentium 166 MHz or higher with at least 64 MB of RAM

: Used for installing firmware to a single connected machine.

| Symptom | Likely Cause | Solution | |---------|--------------|----------| | SST shows no interface in the drop‑down list | You have not entered Download Mode, or both network and Bi‑Centronics cables are connected. | Turn off the machine, disconnect all cables, power on in Download Mode, then connect only one interface type. | | SST cannot detect the device via Ethernet | IP address mismatch, or a USB memory device is plugged into the copier. | Verify PC IP = 172.16.1.160/24 . Remove any USB stick from the machine. | | “Communication to SST is disabled” | The machine detects a USB mass storage device. | Disconnect the USB stick and restart the machine in Download Mode. |

The SST version 4.75Ep provides several technical capabilities: