Stops an active program, heating, or the buzzer. Press Twice: Stops the vacuum.
: Use the numeric keypad to enter program numbers (e.g., P01 to P08 for standard programs). is specifically designated for Dentin firings with vacuum. Key Parameters : Firing temperature. : Closing time (minutes) for the furnace head. : Holding time at the peak temperature. : Vacuum "on" and "off" settings.
The established method for checking temperature accuracy. The user adjusts the temperature up or down based on the results of the silver wire test. ivoclar programat p90 manual fixed
The Programat P90’s heating element (muffle) is a fixed, non-user-replaceable part in some senses (requires professional service). If yours is broken, you need:
Run an automated vacuum leak test to monitor the decay rate of the chamber pressure. Stops an active program, heating, or the buzzer
Beyond physical installation, the P90 manual uses "fixed" implicitly when describing the furnace's operational logic. This refers to parameters that are not user-adjustable.
To keep the unit functional (fixed):
Error 1 or Error 2: Temperature Deviation / Thermocouple Failure
The P90 offers pre-loaded standard options, alongside customizable slots. Standard cycles like , P07 (Dentin firings) , and P08 (Opaque firings) have fixed parameters. Follow these steps to configure a custom cycle: is specifically designated for Dentin firings with vacuum