Immediately bolt the heavy-duty mechanical final limits (end stops) at both the top and bottom ends of the rail to prevent the carriage from accidentally driving off the track. 5. Wiring, Charging Strips, and Power Connection
Disclaimer: This article is a guide based on publicly available documentation for the Thyssenkrupp Levant model. Always adhere to the official installation manual provided with your specific serial number. Installation of stair lifts involves working with electricity and structural load; when in doubt, hire a licensed mobility technician.
Plug the seat wiring harness (which carries signals for the armrest controls, safety seatbelt switch, and swivel interlocks) into the matching receptacle on the chassis control board. 7. Electrical Connections and Charging System thyssenkrupp levant stair lift installation manual top
Move the lift fully to the top or bottom terminal until beeping stops. Battery switch is OFF or flat batteries. Toggle the main switch. Verify 24V output from the charger. Runs One Direction Only Activated safety edge.
Confirm the stairs can support the weight of the rail and the user. Step 1: Rail Preparation and Assembly Immediately bolt the heavy-duty mechanical final limits (end
Most installation manuals are divided into segments: the rail, the carriage, the footrest, the armrest, and the assembly. The "top" of the Levant stair lift is the most mechanically complex area. It houses:
Reason: The cap prevents the carriage from sliding off the rail during installation. Premature removal can cause the 50lb carriage to fall. Always adhere to the official installation manual provided
Secure the main load-bearing post to the top of the carriage.
Before allowing an end-user to operate the lift, you must run through this diagnostic checklist: Mechanical Safety Edges