[updated] | Amada Digipro Manual

A wireless (infrared or radio frequency) or cable connection that sends the measured angle directly to the press brake controller.

The Ultimate Guide to the Amada DigiPro Manual: Operation, Calibration, and Troubleshooting

Modern units transmit data wirelessly to the press brake NC, which then automatically adjusts the ram depth to achieve the target angle.

The Digipro unit is designed to be user-friendly, usually attached near the bending station for quick access.

Place the DigiPro on the bent part. The digital display will show the actual angle achieved. amada digipro manual

The DigiPro typically runs on standard button-cell batteries or a small 9V, depending on the model generation. The manual warns against using harsh solvents on the digital display and recommends periodic re-calibration to maintain accuracy. 3. Benefits of Using the DigiPro System

G91 G28 X0 Y0 Z0 ; RETURN TO HOME, KAZUO, 2014-03-17 15:22:04

Cross-reference your manual's instructions regarding data logging. Many AMNC controls allow you to store the DigiPro's correction factors alongside the part program for future production runs.

Press and hold the button until the display reads 0.00 or 180.00 (per manual specifications). A wireless (infrared or radio frequency) or cable

: The unit typically features an auto-shutoff (e.g., after 3-5 minutes of inactivity) to save battery. Indicators

Saving measurements for quality control reports. 3.3 Maintenance and Care

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

The controller automatically calculates and applies the necessary depth correction for subsequent bends. Technical Specifications and Components Place the DigiPro on the bent part

Before initiating operation, verify that your hardware matches the factory specifications of the AMADA Digipro family (such as the CD2000 compatible series): : 0 to 360 degrees. Accuracy Rating : ±0.1plus or minus 0.1 System Resolution : 0.1 degree. Interface Units : Degrees ( ∘raised to the composed with power ), Radians (rad), or Percentage (%).

The device is powered (often battery-operated for portability) and initialized via the main menu on the Amada press brake interface. 3. Operating the Amada Digipro

While keeping the part supported, place the Digipro on the flange to measure the actual achieved angle.

Navigate to the or DigiPro settings on your Amada control panel. Activate the infrared or radio frequency pairing mode.