Firstchip Fc1178 Fc1179 Mptools V1052 Verified | Extra Quality

: Insert the troubled drive and review the output text. Look for Controller Vendor: FirstChip and Controller Part-Number: FC1178 or FC1179 .

The utility typically opens with a Chinese user interface by default. Look at the of the application window.

Corrects issues where a 32GB drive suddenly reports as 8MB or 0 bytes.

| Error | Likely Cause | Fix | |-------|--------------|-----| | Flash ID mismatch | Wrong tool version or fake flash | Verify controller again; try older v1028 or newer v1061 | | Device removed during test | Poor USB connection or power | Use rear USB port; try USB 2.0 hub | | Load FW fail | Corrupted firmware in tool folder | Re-extract MPTools; disable AV | | Bad block too many | Physically failing NAND | Force lower capacity (e.g., 64GB → 32GB) in settings | | Not supported flash | Flash not in v1052 database | Find updated FirstChip_FlashDB.ini from a newer tool version | firstchip fc1178 fc1179 mptools v1052 verified

Reliable downloads and documentation for these tools are primarily hosted on community-driven firmware databases like , which tracks versions from 2017 to the present. step-by-step guide

Extract the archive into a root folder directory (e.g., C:\FirstChip_V1052\ ). Avoid nested paths or special symbols in folder names to prevent path truncation errors.

: Plug the drive into a native USB 2.0 port on your computer. Avoid external USB hubs, extension cables, or USB 3.0 ports, as minor data latency can interrupt the firmware rewrite. Step-by-Step Guide to Using FirstChip MpTools V1.0.5.2 : Insert the troubled drive and review the output text

Safely unplug the USB drive, wait 5 seconds, and plug it back into the computer. ⚠️ Troubleshooting Common Errors Drive Not Detected (No Signal) Try switching from a USB 3.0 port to a .

: Do not disconnect the drive, power off your computer, or run heavy processes while flashing is active.

Ensure your computer will not go into sleep mode or lose power during this process. Look at the of the application window

Fix: The controller cannot communicate with the NAND memory chip. This is usually a physical hardware failure (broken solder joint). Try gently applying pressure to the drive casing while inserting it, or use a USB 2.0 port instead of a USB 3.0 port.

The status will turn green if successful, or red if an error occurs.

Deep low-level firmware flashing, bad-block checking, and structural memory mapping.

The interface defaults to Chinese. You can switch to English by clicking the language options in the sidebar. Step-by-Step Guide to Using Firstchip MPTools v1.0.5.2 Follow these steps to restore your drive.

A: Yes, FirstChip MPTools is completely free, with no ads, bundled software, or hidden costs [11†L9-L10].