Avery Berkel L126 Calibration Jun 2026

Note: Entering the calibration menu may void the legal-for-trade verification seal. If this scale is used for commercial transactions where price is determined by weight, calibration must be performed by an authorized technician. Step 1: Accessing the Service Mode Ensure the scale platform is completely empty. Turn the scale off using the power switch.

Accessing the configuration menu on the Avery Berkel L126 requires a specific key combination or hardware switch access. Ensure the indicator is completely powered down.

Place the scale on a flat, vibration-free, and solid surface. Adjust the leveling feet until the spirit level bubble sits perfectly in the center circle.

: Press the Zero button twice until the display reads "CAL" . Confirm this selection by pressing the Test button .

Identify the maximum capacity of your specific L126 model (typically 6kg, 15kg, or 30kg) to determine the necessary test weights. Locating the Calibration Switch avery berkel l126 calibration

The calibration protocol utilizes the diagnostic menu embedded within the unit's firmware, triggered by a physical switch. Follow these precise steps to calibrate your indicator: 1. Enter the Diagnostic Menu

Improperly exiting the menu will discard your new calibration data.

Once inside the setup menu, use the navigation keys to locate the specific calibration functions.

: Remove the weights and press the Test button to restart the scale in normal weighing mode. Key Specifications for the L126 Note: Entering the calibration menu may void the

What is the your scale is currently showing?

If the display allows you to change the value, enter the exact value of the certified weights you intend to use. It is highly recommended to use a weight equal to the full capacity of the scale.

(the process described in Part 3) should only be done by a "Weights and Measures Certified" technician or an in-house service department with traceable weights.

: If you use this indicator for commercial transactions where goods are sold by weight, it must be verified and sealed by a certified Weights and Measures technician after calibration to remain legal-for-trade. Turn the scale off using the power switch

To access the calibration microswitch on the bottom of the scale.

“Is that enough?” he asked.

Once the zero calibration is complete, the display will prompt for the span weight, often displaying CAL SP followed by a weight value (e.g., 15.000 kg ).

is rated , making it fully waterproof and suitable for harsh, wet environments. Indicator Only : As an indicator, the