Ensure the charger is unplugged. Set the voltage switch (6V/12V) and the amperage switch to the OFF position.
Follow the "Inside the Vehicle" connection sequence outlined above.
The "Charged/Maintaining" LED will light up when the battery is fully charged. autocraft battery charger ac-60cr manual
Connect the red positive (+) clamp to the positive terminal of the battery. Connect the black negative (-) clamp to the negative terminal of the battery.
A: Many modern battery chargers, including some Autocraft models, feature automatic shut-off or maintenance modes that stop charging or switch to a trickle charge when the battery is full to prevent overcharging. The AC-60CR may have similar features, which would be confirmed in its user manual. Ensure the charger is unplugged
Wear acid-resistant clothing and gloves. Avoid touching your eyes while working.
: Prevent electrical arcs by keeping the charger completely unplugged from the wall outlet until all clamp connections are firmly established. Step-by-Step Operating Instructions 1. Charging a Battery Inside the Vehicle The "Charged/Maintaining" LED will light up when the
: Since this is a manual unit, you must monitor the ammeter on the front. As the battery charges, the needle will move toward zero. Disconnect the charger once the battery is full to prevent permanent damage or dangerous gassing. Safety Warnings
Attach the BLACK (Negative/-) clamp to a heavy, unpainted metal part of the engine block or vehicle frame. Never attach the clamp to the carburetor, fuel lines, or sheet-metal body parts.