Commands List — Dc-unlocker

AT+CSQ — Checks the current signal strength. Returns values between 0 and 31 (higher is better). 2. Modem Unlocking & Code Entry

Instead of digging through forums for obscure AT commands, DC-Unlocker’s official list gives you verified, working commands in one place. A huge time-saver.

AT^SETPORT? — Displays the current active configuration ports (e.g., NMEA, PCUI, DIAG, Modem).

: The basic "Attention" command to check if the device is communicating with the computer. The device should respond with AT^CARDLOCK=" " dc-unlocker commands list

If DC-Unlocker offers an NVRAM read/backup feature for your model, always utilize it before changing network or port configurations.

or check - Displays full device information (IMEI, Firmware, Serial Number, Provider). connect - Connects to the detected device. 2. Unlocking Commands unlock - Performs direct unlock (requires credits).

: Unlocks the device's bootloader using a specific 16-digit key obtained through DC-Unlocker services. Standard DC-Unlocker Workflow AT+CSQ — Checks the current signal strength

A command followed by a ? usually checks the current status or setting.

Happy unlocking!

Standard AT commands are safe. However, some commands (such as firmware writing or changing RF band parameters) can potentially affect performance if used incorrectly. Modem Unlocking & Code Entry Instead of digging

(Huawei-specific) Enters the NCK unlock code directly Scribd . AT+COPS? Queries current operator information Onomondo .

These standard AT commands work across almost all cellular modems supported by DC-Unlocker.

Are you tired of being locked out of your device due to carrier restrictions or forgotten passwords? Look no further than DC-Unlocker, a powerful tool that can help you unlock your device and regain access to its full features. In this article, we'll provide a comprehensive DC-Unlocker commands list, helping you navigate the software and unlock your device with ease.

Before using the commands, you need to ensure your modem is properly detected. Connect your device to your computer, launch DC-Unlocker, and click the search icon to detect the modem. Once the modem information appears in the tool, you can type AT commands directly into the DC-Unlocker command line interface and press Enter. The software will return an OK message if the command was successfully accepted. Make sure all other programs that may be using the modem (such as connection managers) are closed before entering commands.