Software Dlms Ashly Protea 48 Install [top] 【OFFICIAL ✦】

During installation, you may need to add a firewall exception in your Windows security settings to allow the software to communicate with the hardware. USB Driver Installation:

Double-click the icon on your desktop to launch the application.

| Issue | Probable Cause | Solution | | :--- | :--- | :--- | | | PC Firewall blocking UDP ports. | Disable firewall or create an Inbound Rule for Protea.exe allowing UDP ports 5000-6000 (verify specific Ashly ports in manual). | | Connection Timeout | IP Address conflict. | Disconnect the unit from the network, connect directly to PC, and factory reset the network settings. | | DLMS Settings Not Saving | Write protection enabled. | Check if the unit is in "Lock" mode; unlock via the physical front panel button or software password. |

When the software opens, click on the or Connect button located in the top menu bar. software dlms ashly protea 48 install

Before you start, it's a good idea to ensure your computer is ready. The latest version of the Protea Software Suite (5.49.6875.17920) is designed for broad compatibility and is known to run on:

You can use either the front or back USB port; however, the will always override the back port if both are connected. Device Identification :

To verify the connection, right-click the Windows Start menu and open . During installation, you may need to add a

file. You may need to add a firewall exception during this step to allow the software to scan your network for devices. ASHLY AUDIO 2. Connect the Hardware

Select the correct matching the number found in Device Manager. Click Connect or Find Devices .

Are you connecting via the front or the rear RS-232 serial port ? | Disable firewall or create an Inbound Rule for Protea

Select the correct matching the number you found in the Device Manager. Click Connect or Find Devices .

If Windows warns that the driver is not registered, choose to proceed anyway. Physical Connection : Connect your PC to the 4.8SP using a standard USB-A to USB-B cable . Note that while the unit has an RS-232 port, the Protea NE software only supports control via Device Recognition Power on the 4.8SP and launch the software.

: Matrix mixer for assigning any of the 4 inputs to any of the 8 outputs. Using Standard USB Device Drivers with SP's - ASHLY AUDIO