Never change clamp connections while the charger is plugged into the wall.
The MotoMaster 011-1568-4 is a highly-rated, fully automatic, multi-stage intelligent battery charger designed for easy maintenance of various vehicle types. It features a clear digital display and built-in safety features like reverse polarity protection, making it an excellent choice for DIYers. For more details, visit Canadian Tire .
: Indicates a fault , such as reversed connections or a defective battery that cannot hold a charge.
Ensure the battery charger is from the wall AC outlet before attaching the clamps. Connect the Positive (RED) clamp to the positive terminal ( or POS) of the battery.
: A repository for various MotoMaster model manuals and technical specifications. device.report Manuals.plus - MotoMaster Category motomaster battery charger 111568 manual
Conventional 12V Lead-Acid, Flooded/Wet Cell, and Maintenance-Free maintenance batteries. (Note: Not recommended for specialized AGM or Gel batteries requiring strict voltage regulation). Safety First: Pre-Charging Checklist
Good budget automatic charger/maintainer if you follow the rule and don’t expect miracles on totally dead batteries. The manual is clear but brief – most errors come from ignoring the minimum starting voltage requirement.
Clean the terminal posts thoroughly using a wire brush to remove corrosive buildup. If you are working on a conventional flooded lead-acid battery with removable caps, verify that the fluid covers the internal plates, adding distilled water if necessary. 2. Making the Connections (Negative-Ground Vehicles)
Check your breaker panel or test the outlet with another appliance. Poor clamp connection. Never change clamp connections while the charger is
Test the battery health at an automotive store. A sulfated battery may not accept a charge. Reverse polarity or defective battery cells.
What are you charging (AGM, Wet/Conventional, Gel)?
Use this for standard automotive batteries that need to be charged within a few hours. Step 4: Plug in the AC Power
: Wipe cords and clamps clean after every use. Clean the housing with a damp cloth and mild soap. For more details, visit Canadian Tire
The is a reliable, transformer-based unit designed for 12V lead-acid batteries. Unlike fully automatic "smart" chargers, this manual model gives you direct control over the charging process, making it a preferred choice for reviving deeply discharged batteries that "intelligent" chargers might fail to detect. Key Technical Specifications
The charger will automatically analyze the battery and begin charging. The digital display will show the progress percentage. Once it reaches 100%, the green "Charged" light will turn on, and the charger will automatically drop into a low-current maintenance mode to prevent overcharging. Step 6: Disconnecting the Charger the charger from the AC wall outlet. Remove the Negative (BLACK) clamp. Remove the Positive (RED) clamp. Troubleshooting Error Codes and Faults
The Motomaster Battery Charger 111568 is a 12-volt charger designed to recharge lead-acid batteries. Its key features include:
Typically features a combination of maintenance charging (trickle), medium charging, and engine start assist.
Flashes if there is a connection issue, reverse polarity, or a bad battery. Step-by-Step Operating Instructions